A.produce the heat for ignition
B.decrease injection lag
C.increase ignition delay
D.aid in exhausting burnt gases
您可能感興趣的試卷
你可能感興趣的試題
A.low sulfur content in the fuel
B.a loose injector inlet connection
C.late fuel injection
D.high injection pressure
A.Shape of the piston crowns
B.Increasing the compression ratios
C.Increasing the piston crowns
D.Increasing the turbocharger gear ratio
A.Spark plug
B.Heat of compression
C.Carburetor
D.Glow plug
A.low compression temperature
B.low ambient air pressure
C.high lube oil pump pressure
D.high fuel oil booster pump pressure
A.later and closing earlier
B.later and closing later
C.earlier and closing earlier
D.earlier and closing later
最新試題
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
The main purpose of port State control is not to（）
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）
Which of the following items don’t belong to dock repair works?（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）