A.the highest
B.above 3/4
C.1/2 -3/4
D.the lowest
您可能感興趣的試卷
你可能感興趣的試題
A.Ammeter and changeover switch
B.Power factor meter
C.Synchroscope
D.Reverse sequence relay
A.seal water supply be cut off
B.make up water supply be cut off
C.oil outlet valve closed or not open sufficiently
D.the flow rate of oily water is too much
When does auxiliary burner of incinerator put into operation? （）
Ⅰ. start incinerator when it is cold
Ⅱ. the sludge for dealing with is little
Ⅲ. the sludge for dealing with is large
Ⅳ. the water and impurity in sludge are too much
Ⅴ. the temperature in incinerator is low
Ⅵ. dealing with little solid rubbish
A.Ⅰ+Ⅱ+Ⅲ+Ⅴ
B.Ⅰ+Ⅱ+Ⅲ+Ⅳ
C.Ⅰ+Ⅳ+Ⅴ+Ⅵ
D.Ⅰ+Ⅱ+Ⅲ+Ⅵ
A.working at intervals and properly heating
B.warming up to 70℃, increase water supply flow
C.improving impulse of water supply
D.reducing water supply flow
A.MARPOL Annex Ⅲ
B.MARPOL Annex Ⅵ
C.MARPOL Annex Ⅴ
D.MARPOL Annex Ⅳ
最新試題
（） is not installed on the main switchboar.
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
Using a file without a handle may result in （）
The ISPS Code consists of a mandatory section-Part A, which shows（）
The treatment of the fuel oils involves storage, heating, filtering and（）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
If separating effect is not good, which measure should be taken （）
Flame failure in an automatically fired auxiliary boiler can from a/an （）