A.current in the circuit
B.voltage in the circuit
C.inductance in the circuit
D.resistance in the circuit
您可能感興趣的試卷
你可能感興趣的試題
A.opposes any change in the applied voltage
B.opposes any change in the current flow through the circuit
C.aids any changes in the applied voltage
D.aids any changes in the current through the circuit
A.low loads necessitate frequent insulation cleaning
B.exceeding nameplate values shortens useful life
C.energy is wasted if full loading is not utilized
D.power factor correction methods are load dependent
A.The generator and bus transfer section
B.The 450 volt, 60 cycle, 3 phase bus
C.The 120 volt, 3 phase, 60 cycle bus
D.The 24 volt DC bus
A.increases as the square of the current
B.decreases as the square root of the current
C.remains the same, as it is independent of current flow
D.increases in direct proportion as the current
A.1 volt, the output changes 5 volts
B.5 volts, the output changes 1 volt
C.5 volts, the output changes 10 volts
D.10 volts, the output changes 5 volts
最新試題
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
Diesel engine air start system check valves are opened by ()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The main purpose of port State control is not to()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?()
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()