A.gravity separation
B.centrifuge
C.Cyclone
D.Cross-flow membrane filtration
您可能感興趣的試卷
你可能感興趣的試題
A.The requirement for the oil content of bilge water discharged is 15 ppm
B.No discharge in sensitive waters
C.Any discharge in sensitive waters
D.International, national or local requirements have to be observed
A.The high temperature facilitates primary gravity separation
B.Most of the oil and organic solvents are raised to the top layer
C.The high the temperature is, the more the top oil will be collected
D.The high temperature has little use on the separation of emulsified oil
A.Oil leaking from tanks inside engine room
B.Engine room cleaning water
C.Water leaking from the separator sludge tank
D.Sewage
A.reclaims water
B.purges air without losing refrigerant
C.purges air with some loss of refrigerant
D.purges lube oil from the refrigerant
A.re-evaporator
B.receiver
C.dehydrator
D.solenoid
最新試題
The condensers located in various stages of a flash evaporator are cooled by（）
The cetane rating of diesel fuel is an indication of the （）
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
（） is not installed on the main switchboar.
Using a file without a handle may result in （）
Cold weather starting of a diesel engine may be made easier by（）
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）