A.to check and inspect foreign ships
B.to verify the condition of a ship in compliance with requirements of international conventions
C.to fine ships
D.to detain ships
您可能感興趣的試卷
你可能感興趣的試題
A.failure of the proper operation of the main steering gear
B.failure of the proper operation of electrical installations
C.leakage of domestic water pump
D.insulation of exhaust pipes in engine room contaminated by oil
A.failure of the proper operation of emergency generator
B.insulation of piping including exhaust pipes in engine room contaminated by oil
C.improper operation of bilge of bilge of bilge pumping arrangements
D.damaged sanitary pump
A.excess amount of oily-water mixtures in bilges
B.insulation of piping including exhaust pipes in engine room contaminated by oil
C.improper operation of bilge pumping arrangements
D.paint peering off the uptake
A.failure of proper operation of propulsion
B.paint peeling off the uptake
C.no operation procedures for the oil separators
D.damaged sanitary pump
A.no operation procedures for the oil separators
B.engine log book missing
C.the master and the chief engineer are unable to communicate effectively
D.absence of an up-date muster list
最新試題
Flame failure in an automatically fired auxiliary boiler can from a/an ()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
To proceed to the assistance of a ship in distress is()
() is not installed on the main switchboar.
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()