A.detecting faulty combustion in individual cylinders
B.adjusting fuel racks to maintain equal loading between cylinders
C.adjusting the load limit setting of the governor at idle conditions
D.calculating engine horsepower
您可能感興趣的試卷
你可能感興趣的試題
A.tension load twice each crankshaft revolution
B.compression load during power and compression strokes
C.inertia load once every four crankshaft revolutions
D.bending loads at bottom and top dead center
A.cooling water leaving each cylinder
B.fuel oil entering the injector
C.exhaust gases at various locations
D.lube oil at the bearing supplies
A.low water in the expansion tank
B.improperly seated valves
C.low fuel oil pressure
D.worn or broken cylinder liner sealing rings
A.exhaust
B.fuel oil
C.cooling water
D.cylinder liner
A.improperly seating intake valves
B.leaking cylinder liner seal rings
C.late fuel injection timing
D.carbon deposits on the piston
最新試題
Flame failure in an automatically fired auxiliary boiler can from a/an （）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
Using a file without a handle may result in （）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The main purpose of port State control is not to（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
The treatment of the fuel oils involves storage, heating, filtering and（）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.