A.Open the bilge pump for inspection
B.Remove each of the manifold valves
C.Remove only the manifold valve to the affected bilge-well
D.Attempt to pump out another bilge well to determine if the entire system is affected
您可能感興趣的試卷
你可能感興趣的試題
A.too much refrigerant in the system
B.oil entrained in the refrigerant
C.less than a full charge of refrigerant in the system
D.ice crystals forming in the refrigerant
A.with both pumps on line at the same time
B.with one pump on standby
C.with the follow-up gear disconnected
D.only when the rudder is moved amidships
A.high temperature distillate can be re- circulated to induce additional flashing
B.scale formation is not a severe problem
C.cold shocking is more effective in removing scale
D.water purity is greatly increased at high capacity
A.high pressure liquid line
B.low pressure liquid line
C.high pressure vapor line
D.low pressure vapor line
A.more efficiently uses available engine power
B.operates at a lower efficiency at a fixed speed
C.produces the same torque at lower engine power
D.develops its rated power at a lower speed
最新試題
The output volume of a positive fixed displacement pump can be changed only by ().
Thermostatic expansion valves can be adjusted for ().
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its ().
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?()
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will ().
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().
An internal bypass is provided on some hydraulic system suction strainers to help reduce the possibility of ().
If the head pressure of a reciprocating refrigeration compressor is excessive, ().
The temperature differential occurring between the inlet temperature of the fluid to be cooled and the outlet temperature of the cooling medium in a shell-and-tube heat exchanger is greatest in which of the flow designs listed?()