A.It works well with a multihomed environment.
B.It will inspect IP packets that are encapsulated in tunnels， such as GRE，LT2P，or PPTP.
C.uRPF is performed within the CEF switching path.
D.There might be a problem with DHCP as Unicast RPF is blocking packets with a 0.0.0.0 sourceaddress.
您可能感興趣的試卷
你可能感興趣的試題
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
A. PG-R3 will receive up to four queries for 192.168.1.0/24， one each from PG-R2， PG-R4， PGR5，and PG-R6.
B. PG-R3 will receive up eight queries for 192.168.1.0/24， one from PG-R2， two from PG-R4，three from PG-R5， and four from PG-R6.
C. PG-R3 will receive one query for 192.168.1.0/24， since the remote routers， PG-R4， PG-R5， and PG-R6， are natural stubs in EIGRP.
D. PG-R3 will not receive any queries from PG-R2， because there are no alternate paths for 192.168.1.0/24.
A.Caching allows pacing of MSDP messages.
B.Caching reduces join latency.
C.Caching should not be done by an MSDP speaker.
D.Caching is used to update the BGP MDT address family.
A.IGMPv3 has the ability to include or exclude source lists.
B.All IGMPv3 hosts send reports to destination address 224.0.0.22.
C.Only IGMPv2 reports may contain multiple group state records.
D.All IGMPv3 hosts send reports to destination address 224.0.0.23.
E.IGMPv2 does not support the Leave Group message.
A.ip pim ssm
B.ip pim ssm 232.0.0.0 255.0.0.0
C.ip pim ssm range 50
D.access-list 50 permit 232.0.0.0 15.255.255.255
E.ip pim enable default
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
A. 10.1.1.1
B. 10.1.1.2
C. 10.1.1.3
D. The default gateway
最新試題
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）
An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each，terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs，and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem？（）
What is true about Unicast RPF in strict mode？（）
The classic Spanning Tree Protocol （802.1 D 1998） uses which sequence of variables to determine thebest received BPDU？（）
When STP UplinkFast is enabled on a switch utilizing the default bridge priority， what will the new bridgepriority be changed to？（）
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these？（）
In GLBP，which router will answer on client ARP requests？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
What is the correct command to set the router ID for an OSPFv3 process？（）