A.Caching allows pacing of MSDP messages.
B.Caching reduces join latency.
C.Caching should not be done by an MSDP speaker.
D.Caching is used to update the BGP MDT address family.
您可能感興趣的試卷
你可能感興趣的試題
A.IGMPv3 has the ability to include or exclude source lists.
B.All IGMPv3 hosts send reports to destination address 224.0.0.22.
C.Only IGMPv2 reports may contain multiple group state records.
D.All IGMPv3 hosts send reports to destination address 224.0.0.23.
E.IGMPv2 does not support the Leave Group message.
A.ip pim ssm
B.ip pim ssm 232.0.0.0 255.0.0.0
C.ip pim ssm range 50
D.access-list 50 permit 232.0.0.0 15.255.255.255
E.ip pim enable default
Based on the output provided in the exhibit， to which address or location will the router forward a packet sent to 192.168.32.1？（）
A. 10.1.1.1
B. 10.1.1.2
C. 10.1.1.3
D. The default gateway
A.Source-Active Message
B.PIM Join
C.PIM Hello
D.MSDP Register
A.224.0.1.37
B.224.0.1.38
C.224.0.1.39
D.224.0.1.40
最新試題
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
The classic Spanning Tree Protocol （802.1 D 1998） uses which sequence of variables to determine thebest received BPDU？（）
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
What is the correct command to set the router ID for an OSPFv3 process？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）
Which of the following is true about the MPLS header and its EXP field size？（）