A.Injection lag
B.Lube oil dilution
C.Pre-ignition
D.Corrosion
您可能感興趣的試卷
你可能感興趣的試題
A.increase thermal efficiency
B.cause clogging of the fuel system
C.increase the ability of the engine to start in cold weather
D.produce corrosion in the cylinder and exhaust system at low loads
A.the engine to run after the fuel has been secured
B.the engine to over-speed
C.a fire
D.all of the above
A.compression pressure in the cylinder will be higher
B.carbon will accumulate behind the ring
C.combustion gases will penetrate beneath the ring land
D.piston side thrust will be increased
A.copper
B.carbon
C.hydrogen
D.sulfur
A.The cylinder indicator cocks should be opened
B.The sump lube oil scavenge pump should be secured immediately
C.The explosion relief valves should be manually opened
D.The crankcase should remain unopened until the engine has cooled
最新試題
()are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
The treatment of the fuel oils involves storage, heating, filtering and()
Using a file without a handle may result in ()
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
The condensers located in various stages of a flash evaporator are cooled by()
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
The main purpose of port State control is not to()
Diesel engine air start system check valves are opened by ()
The ISPS Code consists of a mandatory section-Part A, which shows()