A.stop the engine by cutting off the cooling water supply
B.stop the engine by closing the air intake
C.slow the engine but not stop it
D.slow the engine to half of normal load
您可能感興趣的試卷
你可能感興趣的試題
A.increase the liner area covered by the oil film
B.maintain an oil film on the lower liner where scuffing is prevalent
C.keep excess oil away from intake and exhaust ports
D.help cushion piston skirt side thrust by providing a hydrodynamic oil wedge
A.the production of high pressure gases
B.the removal of expended combustion gases
C.the admission of air to the cylinder
D.all of the above
A.Speed limiting governor
B.Over-speed governor
C.Over-speed trip
D.Over-speed relay
A.decreased viscosity
B.decreased pour point
C.increased flash point
D.increased viscosity
A.provide a reservoir for cylinder lubrication
B.pump oil into the combustion space for cylinder cooling
C.prevent excessive lubricating oil consumption
D.allow hydraulic oil film formation on the cylinder
最新試題
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Cold weather starting of a diesel engine may be made easier by（）
The ISPS Code consists of a mandatory section-Part A, which shows（）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）