A.Large misalignments can be tolerated between the shaft and engine coupling
B.Slip is held to a minimum when reversing shaft rotation
C.Engine torsion vibrations to the driven shaft are eliminated
D.It aids in maintaining power factor
您可能感興趣的試卷
你可能感興趣的試題
A.actuation
B.sensitivity
C.compensation
D.thrust shaft
A.advance as the load increases
B.retard as the load increase
C.remain unchanged regardless
D.always occur at top dead center
A.compensate for low oil level
B.increase governor promptness
C.prevent governor hunting
D.limit engine load
A.rack position should be adjusted
B.compensating needle valve should be opened fully compensating
C.needle valve should be adjusted to stabilize operation
D.speed limiting device should be adjusted
A.Excessive cylinder liner
B.water in the fuel system
C.Cracked cylinder liner
D.Leaking lube oil cooler
最新試題
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
（） is not installed on the main switchboar.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Diesel engine air start system check valves are opened by （）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
Flame failure in an automatically fired auxiliary boiler can from a/an （）