A.rack position should be adjusted
B.compensating needle valve should be opened fully compensating
C.needle valve should be adjusted to stabilize operation
D.speed limiting device should be adjusted
您可能感興趣的試卷
你可能感興趣的試題
A.Excessive cylinder liner
B.water in the fuel system
C.Cracked cylinder liner
D.Leaking lube oil cooler
A.the bearing had been overheated
B.water was present in the oil
C.the lube oil was not being properly filtered
D.the maximum allowable bearing pressure had been exceeded
A.decrease the time required between cleanings
B.removes all large and small foreign objects
C.ensure a positive flow of oil at all times
D.ensure that all lube oil has been treated twice
A.a dirty lube oil strainer
B.internal water leaks
C.an oil suction line restriction
D.excessive wears of the cooling water pump
A.sliding the camshaft along its axis
B.rotating the cam 180
C.rotating the cam followers 180
D.moving the idler sprockets in the drive chain
最新試題
The additional mark （）in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.
Under MARPOL Code the ship to which it applies has to carry （）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
If separating effect is not good, which measure should be taken （）
To proceed to the assistance of a ship in distress is（）
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish