A.when the remaining charge volume is less than 90 percent of the required VOLUME
B.at each inspection for certification
C.at each annual inspection
D.when the weight loss exceeds 10% of weight of charge
您可能感興趣的試卷
你可能感興趣的試題
A.welding brackets across both ends of the crack
B.chipping out and slot welding the entire crack
C.drilling a hole at each end of the crack
D.cutting a square notch at each end of the crack
A.breaking the fire chemical chain reaction
B.smothering
C.cooling
D.isolating the heat from the fuel
A.quantity of fuel to be received
B.flash point of the fuel as it is received
C.fuel temperature as it is received
D.viscosity of the fuel being received
A.close the static leg filling valve
B.close the overflow tank falling valve
C.reduce the fuel oil pumping rate
D.stop the fuel oil pumping operation
A.The pressure-vacuum relief valve should be reset
B.The tanks should be made seaworthy to prevent contamination
C.The tanks should be sounded to make sure the levels are not rising
D.The tanks should be marked with a bull stamp on the manifold filling valve
最新試題
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
The main purpose of port State control is not to()
The cetane rating of diesel fuel is an indication of the ()
The ISPS Code consists of a mandatory section-Part A, which shows()
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
() is not installed on the main switchboar.
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()