A.increase
B.not change
C.decrease
D.be exactly 60 hertz
您可能感興趣的試卷
你可能感興趣的試題
A.alternating current
B.omnidirectional current
C.direct current
D.sinusoidal current
A.result in immediate power outages
B.damage circuit breakers
C.appear on the ground detection system
D.damage insulation and may cause outages
A.slightly less than the line frequency
B.the same as the line frequency
C.slightly greater than the line frequency
D.All of the above
A.Trip the generator off the switchboard
B.Turn off all electrical equipment
C.Remove the load from the "off going" generator
D.Increase the cycles of the generator staying on the line
A.ohms
B.volts
C.amps
D.watts
最新試題
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
（）are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
If separating effect is not good, which measure should be taken （）
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）
Cold weather starting of a diesel engine may be made easier by（）
The condensers located in various stages of a flash evaporator are cooled by（）