單項選擇題A receiving host computes the checksum on a frame and determines that the frame is damaged.The frame is then discarded.At which OSI layer did this happen?()

A. session
B. network
C. physical
D. data link
E. transport


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題Given an IP address 172.16.28.252 with a subnet mask of 255.255.240.0, what is the correct network addres?()

A. 172.16.16.0
B. 172.16.24.0
C. 172.16.0.0
D. 172.16.28.0

2.單項選擇題Which command can be used to verify the DLCI destination address in a Frame Relay static configuration?()

A. show frame-relay end-to-end
B. show frame-relay map
C. show frame-relay lmi
D. show frame-relay pvc

4.單項選擇題In which circumstance are multiple copies of the same unicast frame likely to be transmitted in a switched LAN?()

A. after broken links are re-established
B. in an improperly implemented redundant topology
C. when upper-layer protocols require high reliability
D. during high traffic periods
E. when a dual ring topology is in use

5.單項選擇題Which command sets and automatically encrypts the privileged enable mode password?()

A. enbale password c1sco
B. secret enable c1sco
C. password enable c1sco
D. enable secret c1sco

最新試題

An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?()

題型:單項選擇題

Which IPsec security protocol should be used when confidentiality is required?()

題型:單項選擇題

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

題型:單項選擇題

If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題

When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()

題型:單項選擇題

Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?()

題型:單項選擇題

A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()

題型:單項選擇題

Which command is used to display the collection of OSPF link states?()

題型:單項選擇題

Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()

題型:單項選擇題