單項選擇題Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?（）

A. STP
B. VTP
C. GVRP
D. SNMP
E. DHCP


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）
Router(config)#router ospf 1
Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

A. The process id is configured improperly
B. The OSPF area is configured improperly
C. The network wildcard mask is configured improperly
D. The network number is configured improperly
E. The AS is configured improperly
F. The network subnet mask is configuerd improperly

2.單項選擇題If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）

A. the IP address of the first Fast Ethernet interface
B. the IP address of the console management interface
C. the highest IP address among its active interfaces
D. the lowest IP address among its active interfaces
E. the priority value until a loopback interface is configured

4.單項選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）

A. Switch1(config)# i nterface fa0 /1 Switch1(config-if)# ip address 192.168.24.3.255.255.255.0
B. Switch1 (config)#interface fa0/1 Switch1 (config-if)# switchport mode trunk
C. Switch 1 (config)# i nterface fa0 /1 Switch1 (config-if)# duplex full Switch1 (config-if)# speed 100
D. Switch1 (config-if)# default-gateway 192.168.24.1
E. Switch1 (config)# line con 0 Switch1(config-line)# password cisco Switch1 (config-line)#login

5.單項選擇題You have been asked to come up with a subnet mask that will allow all three web servers to be on the same network while providing the max number of subnets.Which network address and subnet mask meet this requirement?（）

A. 192.168.252.8 255.255.255.248
B. 192.168.252.8 255.255.255.252
C. 192.168.252.16 255.255.255.240
D. 192.168.252.0 255.255.255.252
E. 192.168.252.16 255.255.255.252

最新試題

What is the default administrative distance of OSPF?（）

題型：?jiǎn)雾?xiàng)選擇題

Which IPsec security protocol should be used when confidentiality is required?（）

題型：?jiǎn)雾?xiàng)選擇題

Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?（）

題型：?jiǎn)雾?xiàng)選擇題

A network administrator is planning a network installation for a large organization.The design requires 100 separate subnetworks,so the company has acquired a Class B network address.What subnet mask will provide the 100 subnetworks required, if 500 usable host addresses are required per subnet?（）

題型：?jiǎn)雾?xiàng)選擇題

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）

題型：?jiǎn)雾?xiàng)選擇題

After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）

題型：?jiǎn)雾?xiàng)選擇題

Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）

題型：?jiǎn)雾?xiàng)選擇題

What is the subnetwork address for a host with the IP address 201.100.5.68/28?（）

題型：?jiǎn)雾?xiàng)選擇題

Which statement is true, as relates to classful or classless routing?（）

題型：?jiǎn)雾?xiàng)選擇題

Which command is used to display the collection of OSPF link states?（）

題型：?jiǎn)雾?xiàng)選擇題