A. The interface configured as FEX fabric requires the MTU to be set to jumbo.
B. The service policy must be applied to the system QoS.
C. The device defaults to jumbo frame support； no changes are required.
D. The switchport in the FEX interface must be set to MTU 9216.
您可能感興趣的試卷
你可能感興趣的試題
A. analyze traffic， device management， and network monitoring
B. DCNM-SAN， DCNM-LAN， and device manager
C. definition of flows， information collection， and data presentation
D. SNMP poll data， MIB analysis， and report generation
A. If none of the authentication servers that are configured for the current authentication mode responds to an authentication request， the DCNM-LAN server falls back to localauthentication.
B. DCNM-LAN only supports TACACS+.
C. Each DCNM-LAN server will have the same device credentials.
D. Administering DCNM-LAN authentication settings requires an authentication license.
E. DCNM-LAN server users are local to the DCNM-LAN server.
A. changing the default policy map from a default MTU of 1500 to 9216
B. using the command system jumbomtu 9216
C. using the command interface MTU 9216
D. configuring the default Ethernet system class to an MTU of 9216 with a new network QoS policy map
A. two IP addresses， one for each supervisor
B. three IP addresses， one virtual IP and one physical IP for each supervisor
C. one IP address that is shared among supervisors
D. none—management 0 will use the IP address from the first SVI that is created
A. Receive port： Enabled， Transmit port： Enabled
B. Receive port： Enabled， Transmit port： Desired
C. Receive port： Enabled， Transmit port： Disabled
D. Receive port： Disabled， Transmit port： Desired
E. Receive port： Desired， Transmit port： Desired
最新試題
Your company wants Server 1/eth0 （vNIC 1） configured so that it always uses Fabric Interconnect A Port Channel 1 （Po1） when it communicates with anything outside of the Cisco UCS domain. However， if vNIC 1 fails over to Fabric Interconnect B using fabric failover， then vNIC 1 can any uplink port on Fabric Interconnect B. Which statements are true？ （）
Which statements are true regarding the Cisco UCS fabric failover feature？ （）
What is required for Cisco UCS C-Series rack server integration with Cisco UCS Manager？（）
Which three statements are possible causes for the "fltAdaptorHostIfLink-down" fault in UCS Manager？ （）
In a Cisco Unified Computing System， What is the "designated receiver" port in end-host mode used for？（）
A Cisco Application Control Engine Appliance （ACE） non-admin context does not support "sticky" configuration. What is the reason for this issue？（）
Which statement is true regarding Backup tasks in Cisco UCS？（）
Where are SAN Port Channel is created in UCS Manager？（）
When will an "all configuration" backup be imported into the Cisco UCS Manager？（）
Server load balancing （SLB） is the process of deciding to which server a load-balancing device should send a client request for service. Which predictors are supported on ACE in order to select the best server to fulfill a client request？ （）