A. changing the default policy map from a default MTU of 1500 to 9216
B. using the command system jumbomtu 9216
C. using the command interface MTU 9216
D. configuring the default Ethernet system class to an MTU of 9216 with a new network QoS policy map
您可能感興趣的試卷
你可能感興趣的試題
A. two IP addresses， one for each supervisor
B. three IP addresses， one virtual IP and one physical IP for each supervisor
C. one IP address that is shared among supervisors
D. none—management 0 will use the IP address from the first SVI that is created
A. Receive port： Enabled， Transmit port： Enabled
B. Receive port： Enabled， Transmit port： Desired
C. Receive port： Enabled， Transmit port： Disabled
D. Receive port： Disabled， Transmit port： Desired
E. Receive port： Desired， Transmit port： Desired
A. NX-OS uses a random MAC address from the IEEE OUI block that is assigned to Cisco.
B. The VDC system MAC is pulled from the active supervisor and concatenated through a hash to ensure uniqueness.
C. NX-OS uses a value that is based on a range that is assigned to the SPROM of the system backplane.
D. The VDC system MAC is based on a range that is allocated to the first line card that is installed in the switch.
A. The module is powered up， and interfaces are in an "admin down" state.
B. The module is denied power， and a syslog message is generated.
C. The module is powered up， and interfaces are allocated to VDC0.
D. The module is powered up， and interfaces are allocated to VDC100.
A. Compatibility with third-party Fibre Channel switches
B. Faster throughput
C. Reduce domain IDs in a Fibre Channel environment
D. Support for increased number of VSANs
E. Support for SAN port channels
最新試題
Given a Cisco Unified Computing System， which is a valid port type in end-host mode？（）
KAL-AP on the Cisco ACE allows communication with Cisco ACE Global Site Selector， to report virtual IP and real server availability. Which statement is true about KAL-AP？（）
What is the purpose of this command in a Cisco Application Control Engine？（） switch/Admin# show np 1 me-stats "-F0 v"
Which three statements are possible causes for the "fltAdaptorHostIfLink-down" fault in UCS Manager？ （）
Which is true when describing a connection replication in Cisco ACE？（）
In a Cisco Unified Computing System， What is the "designated receiver" port in end-host mode used for？（）
What interface is created when an FC Port Channel is created on a Cisco Unified Computing System？（）
Which of the following are supported in Cisco Global Site Selector？ （）
Refer to the exhibit. According to the equipment tab in Cisco UCS Manager， which is true？（）
Your company wants Server 1/eth0 （vNIC 1） configured so that it always uses Fabric Interconnect A Port Channel 1 （Po1） when it communicates with anything outside of the Cisco UCS domain. However， if vNIC 1 fails over to Fabric Interconnect B using fabric failover， then vNIC 1 can any uplink port on Fabric Interconnect B. Which statements are true？ （）