A.2001：DB8：：1 and 2001：DB8：：2
B.2001：DB8：：9 and 2001：DB8：：10
C.2001：DB8：：10 and 2001：DB8：：17
D.2001：DB8：：1 and 2001：DB8：：18
您可能感興趣的試卷
你可能感興趣的試題
A.The autoconfig command is missing from the router interface.
B.IPv6 multicast routing is not enabled on the router interface.
C.IPv6 unicast routing is not enabled on the router interface.
D.The router interface is configured with a /63 mask.
E.The router interface is configured with a /65 mask.
A. anycast address
B. site-local multicast
C. global address of the link
D. unique local address
E. link-local address
A.On-Passive
B.On-Auto
C.Passive-Active
D.Desirable-Auto
E.Active-Active
F.Desirable-Desirable
A. IPv6 prefixes
B. link-local addresses
C. solicited node multicast addresses
D. IPv6 prefixes and topology information
A. An IPv4-compatible tunnel is a static tunnel， but an 6to4 tunnel is a semiautomatic tunnel.
B. The deployment of a IPv4-compatible tunnel requires a special code on the edge routers， but a 6to4 tunnel does not require any special code.
C. An IPv4-compatible tunnel is typically used only between two IPv6 domains， but a 6to4 tunnel is used to connect to connect two or more IPv6 domains.
D. For an IPv4-compatible tunnel， the ISP assigns only IPv4 addresses for each domain， but for a 6to4 tunnel， the ISP assigns only IPv6 addresses for each domain.
最新試題
What is the correct command to set the router ID for an OSPFv3 process？（）
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）
Which two are differences between IGMPv2 and IGMPv3 reports？（）
Which two statements are true about RED？（）
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）
Which multicast address is reserved for cisco-rp-discovery？（）
Which two statements about SA caching are true？（）
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）