A. prefixes received from any other BGP peer and prefixes locally originated via network statements or redistributed
B. all prefixes in its routing table
C. prefixes received from EBGP peers and prefixes locally originated via network statements or redistributed
D. prefixes received from EBGP peers and prefixes received from route reflectors
E. prefixes received from other IBGP peers， prefixes received from EBGP peers， and prefixes redistributed to BGP
F. prefixes received from other IBGP peers and prefixes received from route reflectors
您可能感興趣的試卷
你可能感興趣的試題
A.802.1s supports a reduced number of spanning-tree instances.
B.802.1s has better convergence times than 802.1w.
C.802.1s does not support load balancing over the same physical topology.
D.The CPU utilization for 802.1s is lower than the CPU utilization for 802.1w.
A.service timestamps log datetimec msec
B.logging timestamps msec
C.syslog timestamps hour minute second miliseconds
D.service logging timestamp msec
E.logging service timestamp msec
A.version 1
B.version 5
C.version 7
D.version 8
E.version 9
A.ip sla 1 icmp-echo 1.1.1.1 tos 12
B.ip sla 1 icmp-echo 1.1.1.1 tos 96
C.ip sla 1 icmp-echo 1.1.1.1 precedence 3
D.ip sla 1 icmp-echo 1.1.1.1 dscp 12
A.ip sla monitor low-memory
B.ip sla group schedule
C.ip sla reaction-trigger
D.ip sla enable timestamp
最新試題
In GLBP，which router will answer on client ARP requests？（）
The classic Spanning Tree Protocol （802.1 D 1998） uses which sequence of variables to determine thebest received BPDU？（）
Which multicast address is reserved for cisco-rp-discovery？（）
Which of these statements about penultimate hop popping are true？（）
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）
Choose two commands that are required to enable multicast on a router， when it is known that thereceivers use a specific functionality of IGMPv3.（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
What is the correct command to set the router ID for an OSPFv3 process？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）