A.all routes in the routing table
B.only the IGP and BGP routes in the routing table
C.only the BGP routes in the routing table
D.only the IGP routes in the routing table
您可能感興趣的試卷
你可能感興趣的試題
A.ip vrf CCIE
B.ipv6 vrf CCIE
C.vrf definition CCIE
D.ipv6 vrf definition CCIE
Refer to the exhibit. From the MAC addresses shown in the command output, to which two ports is the multicast stream 225.230.57.199 being forwarded on this switch? ()
A. Fa7/28
B. Fa7/20
C. Gi3/7
D. Fa4/2
E. Fa4/14
F. Fa4/38
G. Fa6/28
H. Fa5/7
A.0
B.1
C.255
D.256
A.6to4
B.6over4
C.ISATAP
D.6PE
E.GRE
A. Both support normal and extended VLAN ranges.
B. ISL is a Cisco proprietary encapsulation method and 802.1Q is an IEEE standard.
C. ISL encapsulates the original frame.
D. Both support native VLANs.
E. 802.1Q does not encapsulate the original frame.
最新試題
Which three options are valid ways to filter routes from a BGP peer?()
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer, assuming it is notconfigured as a route reflector?()
Based on the output provided in the exhibit, to which address or location will the router forward a packet sent to 192.168.32.1?()
Which three message types are valid PIMv2 message types?()
You are the network administrator of an enterprise with a main site and multiple remote sites. Your networkcarries both VOIP and data traffic. You agree with your service provider to classify VOIP and data trafficaccording to the different service RFCs. How can your data and VOIP traffic be marked?()
Which of the following is true about the MPLS header and its EXP field size?()
Which of these statements about penultimate hop popping are true?()
In Layer 2 topologies, spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions?()
Which two are differences between IGMPv2 and IGMPv3 reports?()
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain?()