A. Loop guard can be used with root guard simultaneously on the same port on the same VLAN while UDLD cannot
B. UDLD protects against STP failures caused by cabling problems that create one-way links.
C. Loop guard detects and protects against duplicate packets being received and transmitted on different ports
D. UDLD protects against unidirectional cabling problems on copper and fiber media.
E. Loop guard protects against STP failures caused by problems that result in the loss of BPDUs from a designated switch port.
您可能感興趣的試卷
你可能感興趣的試題
A.followers field
B.MD5 digest
C.VLAN information
D.sequence number
Refer to the exhibit. In the diagram，the switches are running IEEE 802.1w RSPT. On which ports should root guard be enabled in order to facilitate deterministic root bridge election under normal and failure scenarios？（）
A. GE-3/1， GE-3/2
B. FE-2/1， FE-3/2
C. GE-1/1， GE-1/2
D. GE-4/1， GE-4/2
E. GE-2/1， GE-2/2
F. GE-3/1， GE-3/2， GE-4/1， GE-4/2， FE-2/1， FE-3/2
A.runts
B.FCS errors
C.interface resets
D.late collisions
A.mpls ip cef
B.port-channel ip cef
C.mpls ip port-channel cef
D.port-channel load balance
E.mpls ip load-balance
F.ip cef EtherChannel channel-id XOR L4
G.ip cef connection exchange
Refer to the exhibit. In the diagram， the switches are running IEEE 802.1s MST. Which ports are in the MST blocking state？（）
A. GE-1/2 and GE 2/1
B. GE-1/1 and GE-2/2
C. GE-3/2 and GE 4/1
D. no ports are in the blocking state
E. There is not enough information to determine which ports are in the blocking state.
最新試題
Which of these statements about penultimate hop popping are true？（）
Which three message types are valid PIMv2 message types？（）
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
What is the correct command to set the router ID for an OSPFv3 process？（）
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）
What is also called Type 0 authentication in OSPF on Cisco Routers？（）