A.produces pressure
B.imparts energy to a fluid to move it from level ‘A’ to level ‘B’
C.creates a vacuum to move a liquid in all installation
D.is to develop a pressure differential
您可能感興趣的試卷
你可能感興趣的試題
A.firing for extended periods in the low fire mode
B.overheating, due to waterside deposits
C.varying the water level above the crown sheet
D.carrying excessive alkalinity in the boiler water
A.decrease the velocity of gases flowing past the tubes
B.increase the rate of heat transfer
C.reduce accumulations carbon deposits
D.direct the flow of gases
A.fuel oil supply temperature is normal
B.burner electrode is incorrectly positioned
C.fuel／air ratio is incorrect
D.ignition current is too low
A.when the boiler has been secured long enough for most solids to settle
B.when the boiler has been cooled to ambient temperature
C.only after raising the water level to within 0~5 inch of the high water cutout only
D.after bypassing the low pressure
A.completely drain the boiler in an emergency
B.prevent sludge from forming in the drum
C.remove floating impurities from the boiler water surface
D.remove settled solids from the water drum
最新試題
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
Using a file without a handle may result in （）
Diesel engine air start system check valves are opened by （）
The cetane rating of diesel fuel is an indication of the （）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The ISPS Code consists of a mandatory section-Part A, which shows（）
The condensers located in various stages of a flash evaporator are cooled by（）
Cold weather starting of a diesel engine may be made easier by（）
Which of the following items don’t belong to dock repair works?（）