A.To add power to the engine
B.To keep the engine firmly attached to its supporting base
C.To keep moving engine part in their proper relative positions
D.To rotate the crankshaft
您可能感興趣的試卷
你可能感興趣的試題
A.droop
B.dead banding
C.dash potting
D.hunting
A.cylinder head cracks
B.piping joints
C.pump leaking
D.all of the above
A.reduce the ring groove wear rate
B.seal against crankcase vapors
C.lessen the wear on aluminum part of the cylinder
D.allow for the greater expansion rate of aluminum
A.a leaking fuel injector nozzle
B.a clogged air filter
C.excessively early fuel injection
D.malfunctioning valves
A.An alarm device with audible and visible signals is required for all cooling water systems
B.Propulsion engines with bores over 200 mm are to be fitted with cooling water jackets
C.Each totally enclosed cooling system shall be provided with a suitable head tank
D.Drain cocks are to be provided at the lowest points of all cylinder water jackets
最新試題
The cetane rating of diesel fuel is an indication of the （）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Using a file without a handle may result in （）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
The ISPS Code consists of a mandatory section-Part A, which shows（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）