A.excessive pump speed
B.excessive suction head
C.worn wearing rings
D.gross pump misalignment
您可能感興趣的試卷
你可能感興趣的試題
A.Distillation is the process of boiling seawater to produce vapor which is condensed into fresh water
B.Evaporation is the second part of the distillation process where brine is removed
C.Brine is the result of condensed sea water vapor
D.Distillate is the product resulting from the evaporation of fresh water vapor
A.absolute humidity
B.specific humidity
C.effective humidity
D.relative humidity
A.drain water from the air receiver
B.drain water from the cylinders
C.delay the compression process until the motor is up to speed
D.check pump alignment
A.face shield
B.a respirator
C.rubber gloves
D.an all purpose gas mask
A.lantern rings
B.bearings
C.easing volutes
D.wearing rings
最新試題
If the head pressure of a reciprocating refrigeration compressor is excessive, （）.
When the steering gear is in operation, you should （）.
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?（）
The usual symptoms of cavitation in a centrifugal pump is （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
The control mode in which the final control element is moved from one of two flexed positions to the other is known as （）.
The general purpose of a heat exchanger is to （）.