單項選擇題Which command will configure a default route on a router?()

A. router(config)# ip route 0.0.0.0 10.1.1.0 10.1.1.1
B. router(config)# ip default-route 10.1.1.0
C. router(config)# ip default-gateway 10.1.1.0
D. router(config)# ip route 0.0.0.0 0.0.0.0 10.1.1.1


您可能感興趣的試卷

你可能感興趣的試題

2.多項選擇題You are a technician at TestKing. Your newly appointed TestKing trainee wants to know what the CDP is.What would your reply be?()

A. It is globally enabled by default on Cisco routers.
B. It is globally enabled by default on all routers.
C. It is a proprietary protocol.
D. It is a non-proprietary protocol.
E. It can be used to gather hardware and protocol information about neighbor devices.

3.單項選擇題You are implementing a new frame relay network to provide connectivity between you offices. To do this, you set up the frame relay network using point-to-point subinterfaces.Which of the following does NOT need to be configured?()

A. The Frame Relay encapsulation on the physical interface.
B. The local DLCI on each subinterface.
C. An IP address on the physical interface.
D. The subinterface type as point-to-point.

4.單項選擇題Which one of the following commands would you enter to terminate a VTY line session?()

A.close
B.disable
C.disconnect
D.suspend
E.exit
F.None of the above

最新試題

Which of the following if addresses can be assigned to host devices?()

題型:多項選擇題

Which connections allow the use of full-duplex Ethernet?()

題型:多項選擇題

What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? ()

題型:單項選擇題

Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?()

題型:多項選擇題

The following access list was applied outbound on he E0 interface connected to the 192.168.1.8/29 LAN:access-list 123 deny tcp 192.168.1.8 0.0.0.7 eq 20 anyaccess-list 123 deny tcp 192.168.1.9 0.0.0.7 eq 21 anyWhat effect will this access list have?()

題型:單項選擇題

What is the subnetwork address for a host with IP address 201.100.5.68/28?()

題型:單項選擇題

Which of the following correctly describe steps in the OSI data encapsulation process?()

題型:多項選擇題

New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? ()

題型:單項選擇題

A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?()

題型:多項選擇題

A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? ()

題型:多項選擇題