A. perform flow lookups
B. intercept packets on service enabled ports
C. run packets through the vPath flow manager
D. classify the packets
E. flow manager emits an action for the packets
F. enforce the action determined by the flow manager
您可能感興趣的試卷
你可能感興趣的試題
Given the following configuration， what command can be used to determine the physical path that traffic will be sent out upon？（）
Port-profile type Ethernet name vm-data
Switchport mode trunk
Switchport trunk allowed vlan 200-210
Channel-group auto mode on mac-pinning
State enabled
Vmware port-group
No shut
Port-profile type vethernet name vlan-200
Switchport mode access Switchport vlan 200
State enabled Vmware port-group No shut
A. module vem X execute vemcmd show trunk
B. show module 3 internal pinning
C. module vem X execute vemcmd show port
D. show module vem mapping
E. show interface vethX pinning
A. Upstream switch
B. Virtual Supervisor Module
C. VMware distributed switch
D. VMware vSwitch
E. Service virtual machine
A. All vEthernet ports are trusted， and all Ethernet ports such as uplinks and port channels are trusted.
B. All vEthernet ports are not trusted， and all Ethernet ports such as uplinks and port channels are not trusted.
C. All vEthernet ports are trusted and all Ethernet ports such as uplinks and port channels are not trusted.
D. All vEthernet ports are not trusted and all Ethernet ports such as uplinks and port channels are trusted.
n1kv-l3（config）# show lacp offload status
Current Status ： Enabled
Running Config Status ： Enabled
Saved Config Status ： Disabled
What two facts does the output signify？ （）
A. LACP is enabled on the Nexus 1000v.
B. LACP will be offloaded to the upstream switch.
C. LACP will be negotiated to the VM.
D. LACP is negotiated by the VSM.
E. LACP is negotiated by the VEM in all instances.
A. intelligent traffic steering to the VSG
B. offloading the processing from the VSG to the VEM
C. intelligent traffic steering to the VNMC
D. offloading the processing from the VSG to the flow manager
E. deep packet inspection
最新試題
Which three statements are possible causes for the "fltAdaptorHostIfLink-down" fault in UCS Manager？ （）
What would be the cause for the following fault in UCS Manager？（） "ether VIF x / xxx down， reason： ENM source pinning failed"
Server load balancing （SLB） is the process of deciding to which server a load-balancing device should send a client request for service. Which predictors are supported on ACE in order to select the best server to fulfill a client request？ （）
Application Control Engine （ACE） can check the health of servers and server farms by configuring health probes （which are sometimes referred to as keepalives）. A probe can be one of many types. Which are valid ACE probes？ （）
When will an "all configuration" backup be imported into the Cisco UCS Manager？（）
Refer to the exhibit.The Cisco UCS domain is operating in switching mode. A network administrator notices that no traffic is traversing the uplinks on Fabric Interconnect B （Path C）. Which actions might be used to change this behavior？（）
What is the purpose of this command in a Cisco Application Control Engine？（） switch/Admin# show np 1 me-stats "-F0 v"
In a Cisco Unified Computing System， What is the "designated receiver" port in end-host mode used for？（）
Which statement is true regarding Backup tasks in Cisco UCS？（）
What is the appliance port used to connect to in a Cisco Unified Computing System？（）