A.PIM sparse mode is being used.
B.PIM dense mode is being used.
C.The BGP multicast address family has not been configured.
D.IGMP version 3 is being used.
E.IP PIM neighbor filters have not been applied.
您可能感興趣的試卷
你可能感興趣的試題
A.ip sla 1 icmp-echo 1.1.1.1 tos 160
B.ip sla 1 icmp-echo 1.1.1.1 tos 20
C.ip sla 1 icmp-echo 1.1.1.1 precedence 5
D.ip sla 1 icmp-echo 1.1.1.1 dscp 20
A.The phones are not sending traffic with the correct DSCP value.
B.The Cisco CallManager is not marking the traffic correctly.
C.This is most likely a bug on the CE routers.
D.Your LAN QoS is incorrectly configured.
A.routing issue
B.denial-of-service attack
C.MAC flooding
D.spanning-tree recalculation
E.Layer 2 loop
F.ARP spoofing attack
A. The switches are not the same model
B. You are not using the correct SFP
C. You are not using correct optical media converters
D. Configuration should be modified, because the distance is longer
A. Tunnel IPv6 over IPv4 to connect far-end IPv6 networks
B. Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible
C. Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible
D. What is the meaning of EUI-64 and how does it work?
E. Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
最新試題
What is the correct command to set the router ID for an OSPFv3 process?()
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?()
On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails, what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once (there are no dropped or retransmitted packets)?()
What is also called Type 0 authentication in OSPF on Cisco Routers?()
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link,but only allow eachindividual flow to use 1 MB/s?()
Which multicast address is reserved for cisco-rp-discovery?()
Which two are differences between IGMPv2 and IGMPv3 reports?()
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these?()
When STP UplinkFast is enabled on a switch utilizing the default bridge priority, what will the new bridgepriority be changed to?()
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain?()