單項(xiàng)選擇題

Refer to the exhibit. In this network， R1 has been configured to advertise a summary route， 192.168.0.0/22， to R2. R2 has been configured to advertise a summary route， 192.168.0.0/21， to R1. Both routers have been configured to remove the discard route （the route to null created when a summary route is configured） by setting the administrative distance of the discard route to 255.What will happen if R1 receives a packet destined to 192.168.3.1？（）

A.The packet will loop between R1 and R2.
B.It is not possible to set the administrative distance on a summary to 255.
C.The packet will be forwarded to R2， where it will be routed to null0.
D.The packet will be dropped by R1， since there is no route to 192.168.3.1.


您可能感興趣的試卷

你可能感興趣的試題

1.問(wèn)答題ARP和反向ARP啥意思？
2.單項(xiàng)選擇題In order to configure two routers as anycast RPs，which of these requirements，at a minimum， must be satisfied？（）

A.Multicast Source Discovery Protocol mesh-groups must be configured between the two anycast RPs.
B.The RPs must be within the same IGP domain.
C.Multicast Source Discovery Protocol must be configured between the two anycast RPs.
D.The two anycast RPs must be IBGP peers.

4.單項(xiàng)選擇題The ip pim autorp listener command is used to do which of these？（）

A.enable a Cisco router to "passively" listen to Auto-RP packets without the router actively sending or forwarding any of the packets
B.allow Auto-RP packets in groups 224.0.1.39 and 224.0.1.40 to be flooded in dense mode out interfaces configured with the ip pim sparse-mode command
C.enable the use of Auto-RP on a router
D.configure the router as an Auto-RP mapping agent