A.source MAC address
B.source IP address
C.source switch port
D.destination IP address
E.destination port address
F.destination MAC address
您可能感興趣的試卷
你可能感興趣的試題
A.data link
B.network
C.physical
D.transport
A.RSTP significantly reduces topology reconverging time after a link failure.
B.RSTP expends the STP port roles by adding the alternate and backup roles.
C.RSTP port satates are blocking,discarding,learing,or forwarding.
D.RSTP also uses the STP proprsal-agreement sequence.
E.RSTP use the same timer-baseed process as STP on point-to-point links.
F.RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.
Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?()
A.trunk mode mismatches
B.vlans that do not correspond to a unique IP subnet
C.native vlan mismatches
D.allowing only vlan 2 on the destination.
Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links are operating at the same bandwidth? ()
A.Switch A - Fa0/0
B.Switch A - Fa0/1
C.Switch B - Fa0/0
D.Switch B - Fa0/1
E.Switch C - Fa0/0
F.Switch C - Fa0/1
A.when a packet is received from an 802.1Q trunk,the vlan id can be determined from the source MAC address table.
B.unkown unicast frames are retransmitted only to the ports that belong to the same vlan
C.ports between switches should be configured in access mode so that vlans can span across the ports
D.broadcast and multicast frames are retransmitted to ports that are configured on different vlan.
最新試題
Which one of these is a valid HSRP Virtual Mac Address?()
Which statement describes the process ID that is used to run OSPF on a router ?()
What command visualizes the general NetFlow data on the command line?()
What is the default Syslog facility level?()
Refer to the exhibit.If the devices produced the given output,what is the cause of the EtherChannel problem?()
What command instructs the device to timestamp Syslog debug messages in milliseconds?()
What are three factors a network administrator must consider before implementing Netflow in the network?()
What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow?()
What are the three things that the Netflow uses to consider the traffic to be in a same flow ?()
In GLBP, which router will respond to client ARP requests?()