A.Viscosity
B.acid content
C.heating value
D.ignition quality
您可能感興趣的試卷
你可能感興趣的試題
A.Viscosity
B.Sulfur content
C.Pour point
D.Cetane number
A.Exhaust energy would draw excess air
B.The inertia of the turbocharger rotor causes a time lag which delays the turbocharger speed increase
C.Exhaust gas pumping losses are increased due to turbine windage
D.Exhaust gas back pressure falls slightly due to increased nozzle action
A.use of low viscosity oil in cold weather
B.increased moisture content of inlet air in cold weather
C.increased drag of pistons and bearings due to increased oil viscosity
D.higher compression pressures reached due to smaller clearances existing in the engine during cold weather
A.octane number
B.cetane number
C.viscosity in Saybolt seconds
D.air fuel ratio
A.Decreasing scavenge air pressure
B.Increasing exhaust temperatures before the turbine
C.Reduction in engine speed
D.All of the above
最新試題
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
Cold weather starting of a diesel engine may be made easier by（）
The cetane rating of diesel fuel is an indication of the （）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
（）are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）