A.the water produced during combustion
B.the sulfur in the fuel
C.unburned fuel oil
D.all of the above
您可能感興趣的試卷
你可能感興趣的試題
A.early injection timing
B.worn orifices in the injection nozzles
C.worn or scored cylinder liners
D.using a fuel with too low of a cetane number
A.during the valve overlap period
B.with only the exhaust valve open
C.at a pressure below atmospheric
D.without cooling the cylinders or pistons
A.excessive piston to liner clearance
B.excessive dirt beneath the piston crown that reduces heat transfer
C.faulty nozzle spray
D.all of the above
A.an increased flash point
B.higher lube oil pressures
C.an increased viscosity
D.lower lube oil pressures
A.The fuel metering will vary
B.The fuel will explode
C.The cylinder head will crack
D.The engine will stop
最新試題
The treatment of the fuel oils involves storage, heating, filtering and()
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?()
()are used to digest the sewage to produce innocuous sludge in a biological sewage treatment plant.
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
If separating effect is not good, which measure should be taken ()
The main purpose of port State control is not to()
The condensers located in various stages of a flash evaporator are cooled by()