A.Sea water is heated to boiling temperature while under a vacuum
B.Sea water is passed over heated plates in a thin film
C.Heated sea water is injected into a vacuum chamber
D.Sea water is forced through a heated eductor
您可能感興趣的試卷
你可能感興趣的試題
A.Vapor pockets formed in the suction flow stream
B.Rough easing volute surfaces
C.Worn wearing rings
D.Heavy fluid in the flow stream
A.primarily to lubricate the shaft seals
B.due to the inability of this type of pump to lift water to cover the suction (eye) of the impeller
C.to initially unload the pump by having its head pressure equal to discharge pressure
D.in order to overcome the potential energy of water in the discharge line
A.humidification
B.dehumidification
C.vaporization
D.evaporation
A.latent heat of vaporization
B.sensible heat
C.refrigerating effect
D.specific heat of vaporization
A.Ball float
B.Thermostatic
C.Bimetallic
D.Impulse
最新試題
The major source of chemical contaminants in hydraulic fluid is （）.
The usual symptoms of cavitation in a centrifugal pump is （）.
A pressure drop through the refrigerant liquid line may cause （）.
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.
Who is responsible for ensuring that someone is assigned to close the watertight doors in an emergency?（）
The rate of heat transfer from a hot region to a cold region is affected most by the （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.